Configuring DHCP Relay DHCPv6 Relay Configuration Overview
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 21-25
Configuring the DHCPv6 Relay Destination
The DHCPv6 relay enabled interface should be configured with the relay destination (DHCP server) to
which the DHCPv6 client messages are sent. To configure the relay destination, use the ipv6 dhcp relay
destination command. For example:
-> ipv6 dhcp relay int1 destination 3001::3
A maximum of five relay destinations can be configured for an interface. The DHCPv6 relay for the
interface will be automatically disabled when all the relay destinations configured for that interface are
removed.
Viewing the DHCPv6 Relay configuration
The interface for which the DHCPv6 relay is configured, the relay destinations, and the status of the
DHCPv6 relay can be viewed. To view the DHCPv6 relay configuration, use the show ipv6 dhcp relay
command. For example:
-> show ipv6 dhcp relay
DHCPv6 Relay: Enabled
Interface Relay Destination(s) Status
---------------------------+-----------------------------------------+--------
vlan-41 ff02::1:2 Enabled
vlan-103 2001:dbc8:8003::17 Disabled
2001:dbc8:8004::99
vlan-200 fe80::cd0:deff:fe28:1ca5 vlan-201 Enabled
tunnel-2 2001:dbc8:a23::ea77 Enabled
Note. If the relay destination is a local-link, then the interface-ID of the local-link should be specified.
To Next Page
Loading...
