Configuring IP Multicast Switching IPMS Default Values
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 25-2
• “Modifying IPMSv6 Parameters” on page 25-33.
• “IPMSv6 Application Example” on page 25-44.
• “Displaying IPMSv6 Configurations and Statistics” on page 25-47.
IPMS Default Values
The table below lists default values for the OmniSwitch IPMS implementation.
Parameter Description Command Default Value/Comments
Administrative Status ip multicast admin-state disabled
Flood initial unknown multicast
traffic
ip multicast flood-unknown disabled
IGMP Querier Forwarding ip multicast querier-
forwarding
disabled
IGMP Version ip multicast version version 2
IGMP Query Interval ip multicast query-interval 125 seconds
IGMP Last Member Query Interval ip multicast last-member-
query-interval
10 tenths-of-seconds
IGMP Query Response Interval ip multicast query-response-
interval
100 tenths-of-seconds
IGMP Router Timeout ip multicast router-timeout 90 seconds
Source Timeout ip multicast source-timeout 30 seconds
IGMP Querying ip multicast querying disabled
IGMP Robustness ip multicast robustness 2
IGMP Spoofing ip multicast spoofing disabled
IGMP Zapping ip multicast zapping disabled
Use an all-zero source IPv4 address
for IGMP query packets
ip multicast zero-based-query enabled
To Next Page
Loading...
