Configuring RIP Verifying the RIP Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 19-19
Verifying the RIP Configuration
A summary of the show commands used for verifying the RIP configuration is given here:
For more information about the displays that result from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
show ip rip Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
show ip rip routes Displays the RIP routing database. The routing database contains all
the routes learned through RIP.
show ip rip interface Displays the RIP interface status and configuration.
show ip rip peer Displays active RIP neighbors (peers).
show ip redist Displays the currently configured RIP redistribution filters.
To Next Page
Loading...
