Configuring Dynamic Link Aggregation Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 9-22
Modifying the Partner Port System ID
By default, the partner port system ID ( the MAC address used as the system ID on dynamic aggregate
partner ports) is 00:00:00:00:00:00. The following subsections describe how to configure a user-specified
value and how to restore the value to its default value with the linkagg lacp port partner admin system-
id command.
Configuring the Partner Port System ID
You can configure the partner port system ID by entering linkagg lacp port, the slot number, a slash (/),
the port number, partner admin system-id, and the user-specified partner administrative system ID (the
MAC address in hexadecimal format).
For example, to modify the system ID of dynamic aggregate partner port 49 in slot 6 to
00:20:da:06:ba:d3, enter:
-> linkagg lacp port 6/49 partner admin system-id 00:20:da:06:ba:d3
For example, to modify the system ID of dynamic aggregate partner port 49 in slot 6 to
00:20:da:06:ba:d3, enter:
-> linkagg lacp port 6/49 partner admin system-id 00:20:da:06:ba:d3
Restoring the Partner Port System ID
To remove a user-configured system ID from a dynamic aggregate group partner port configuration use
the no form of the linkagg lacp port partner admin system-id command by entering linkagg lacp agg,
the slot number, a slash (/), the port number, and the partner admin system-id parameters.
For example, to remove a user-configured system ID from dynamic aggregate partner port 2 in slot 6,
enter:
-> no linkagg lacp port 6/2 partner admin system-id
Modifying the Partner Port System Priority
By default, the administrative priority of a dynamic aggregate group partner port is 0. The following
subsections describe how to configure a user-specified value and how to restore the value to its default
value with the linkagg lacp agg partner system-priority command.
Configuring the Partner Port System Priority
You can configure the administrative priority of a dynamic aggregate group partner port to a value ranging
from 0 to 255 by entering linkagg lacp port, the slot number, a slash (/), the port number, partner
admin-system-priority, and the user-specified administrative system priority.
For example, to modify the administrative priority of a dynamic aggregate partner port 49 in slot 4 to 100,
enter:
-> linkagg lacp port 4/49 partner admin-system-priority 100
For example, to modify the administrative priority of dynamic aggregate partner port 49 in slot 4 to 100
and specify that the port is a Gigabit Ethernet port, enter:
-> linkagg lacp port 4/49 partner admin-system-priority 100
To Next Page
Loading...
