Alcatel-Lucent OmniSwitch 6860 Series User Manual

Configuring Spanning Tree Parameters Configuring STP Port Parameters
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 6-39
instance number is not required. For example, the following command configures the Spanning Tree mode
on port 1/24 for the flat mode instance:
-> spantree cist port 1/24 mode blocking
Mode for Link Aggregate Ports
Physical ports that belong to a link aggregate do not participate in the Spanning Tree Algorithm. Instead,
the algorithm is applied to the aggregate logical link (virtual port) that represents a collection of physical
ports.
To change the port mode for a link aggregate, use the spantree vlan mode or the spantree cist mode
command described above, but specify a link aggregate control (ID) number instead of a slot and port. For
example, the following command sets the port mode for link aggregate 10 associated with VLAN 755 to
blocking:
-> spantree vlan 755 linkagg 10 mode blocking
For more information about configuring an aggregate of ports, see Chapter 8, “Configuring Static Link
Aggregation,” and Chapter 9, “Configuring Dynamic Link Aggregation.”

Alcatel-Lucent OmniSwitch 6860 Series Specifications

General

Model	OmniSwitch 6860 Series
Category	Switch
Maximum Ports	48
Switching Capacity	Up to 176 Gbps
Operating System	AOS (Alcatel-Lucent Operating System)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Port Types	10/100/1000BASE-T, SFP+, QSFP+
Ports	24, 48
Power over Ethernet (PoE)	Yes
Stacking	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Form Factor	1U rack-mountable
MAC Address Table Size	32, 000
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 mm x 420 mm x 44 mm (17.3 in x 16.5 in x 1.73 in)
Power Supply	AC or DC (depending on model)
Power Consumption	Varies by model and configuration