Configuring Loopback Detection LBD Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 7-2
LBD Defaults
The following table shows LBD default values.
Parameter Description Command Default Value/Comments
LBD administrative state loopback-detection Disabled
LBD remote-origin
administrative state
loopback-detection Disabled
LBD status of a port loopback-detection port Disabled
Remote-origin LBD status of a
port
loopback-detection port Disabled
LBD service-access state loopback-detection service-
access
Disabled
Transmission time is the time
period between LBD packet
transmissions.
loopback-detection service-
access
30 seconds
Autorecovery time is the time
period in which the switch is
recovered from the shutdown
state.
loopback-detection
autorecovery-timer
300 seconds
To Next Page
Loading...
