Configuring 802.1AB 802.1AB Defaults Table
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 13-2
802.1AB Defaults Table
The following table shows the default settings of the configurable 802.1AB parameters.
Parameter Description Command Default Value/Comments
Transmit time interval for LLDPDUs lldp transmit interval 30 seconds
Transmit hold multiplier value lldp transmit hold-multiplier 4
Reinit delay lldp reinit delay 2 seconds
Notification interval lldp notification interval 5 seconds
LLDPDUs transmission lldp lldpdu Transmission and Reception
Per port notification lldp notification Disable
Management TLV lldp tlv management Disable
802.1 TLV lldp tlv dot1 Disable
802.3 TLV lldp tlv dot3 Disable
LLDP Media Endpoint Device lldp tlv med Disable
To Next Page
Loading...
