Configuring QoS QoS Policy Overview
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 26-32
For specific information about how to configure policy conditions and actions to create a policy rule, see
“Creating Policies” on page 26-42.
Condition and Action Combinations
Conditions and actions are combined in policy rules. The CLI prevents you from configuring invalid
condition/action combinations that are never allowed; however, the following table provides a quick
reference for determining which condition/action combinations are not valid. Each row represents a policy
condition or conditions combined with the policy action or actions in the same row.
Policy Condition/Action Combinations
Conditions Actions Supported When?
multicast IP address or network group all actions never, except with disposition action
multicast IPv6 address all actions never, except with disposition and
mirror actions
destination VLAN all actions never, except with disposition action
in a multicast rule (a rule that uses
the “multicast” keyword and only
applies to IGMP traffic)
destination slot/port or port group all actions bridging only
To Next Page
Loading...
