Configuring DHCP Relay DHCP Relay Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 21-2
DHCP Relay Defaults
The following table describes the default values of the DHCP Relay parameters:
Parameter Description Command Default Value/Comments
Default UDP service ip udp relay service BOOTP/DHCP
Forward delay time value for DHCP Relay ip helper forward-delay 3 seconds
Maximum number of hops ip helper maximum-hops 4 hops
Packet forwarding option ip helper standard
ip helper per-vlan-only
Standard
Automatic switch IP configuration for
default VLAN 1
ip helper boot-up Disabled
Automatic switch IP configuration packet
type (BootP or DHCP)
ip helper boot-up enable BootP
Relay Agent Information Option ip helper agent-
information
Disabled
To Next Page
Loading...
