Configuring Application Monitoring and Enforcement In This Chapter
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 29-2
In This Chapter
This chapter provides an overview of the AppMon feature and describes how to configure this feature
through the Command Line Interface (CLI). CLI commands are used in the configuration examples; for
more details about the syntax of commands, see the OmniSwitch AOS Release 8 CLI Reference Guide.
The following information and procedures are included in this chapter:
• “AppMon Defaults” on page 29-3.
• “Application Monitoring and Enforcement Overview” on page 29-4
• “Application Signature File/Kit” on page 29-8
• “Quick Steps for Configuring AppMon” on page 29-7.
• “Configuring AppMon” on page 29-10
• “Configuration Guidelines” on page 29-11
• “Verifying AppMon Configuration” on page 29-20.
To Next Page
Loading...
