Alcatel-Lucent OmniSwitch 6860 Series

Configuring UDLD Verifying the UDLD Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 2-8
Clearing UDLD Statistics
To clear the UDLD statistics, use the clear udld statistics port command. For example, to clear the
statistics for port 4 on slot 1, enter:
-> clear udld statistics port 1/4
To clear the UDLD statistics on all the ports, enter:
-> clear udld statistics
Verifying the UDLD Configuration
To display UDLD configuration and statistics information, use the show commands listed below:
For more information about the resulting display from these commands, see the OmniSwitch AOS Release
8 CLI Reference Guide. An example of the output for the show udld configuration port and show udld
statistics port commands is also given in “Quick Steps for Configuring UDLD” on page 2-3.
show udld configuration Displays the global status of UDLD configuration.
show udld configuration port Displays the configuration information for all UDLD ports or for
a particular UDLD port on the switch.
show udld statistics port Displays the UDLD statistics for a specific port.
show udld neighbor port Displays the UDLD neighbor ports.
show udld status port Displays the UDLD status for all ports or for a specific port.