Configuring IPsec Verifying IPsec Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 18-23
Verifying IPsec Configuration
To display information such as details about manually configured IPsec Security Associations and other
IPsec parameters configured on the switch, use the show commands listed in the following table::
For more information about the resulting displays form these commands, see the “IPsec Commands”
chapter in the OmniSwitch AOS Release 8 CLI Reference Guide.
Examples of the above commands and their outputs are given in the section “Configuring IPsec on the
OmniSwitch” on page 18-10.
show ipsec sa Displays information about manually configured IPsec SAs.
show ipsec key Displays encryption and authentication key values for the manually
configured IPsec SA.
show ipsec policy Displays information about IPsec Security Policies configured for the
switch.
show ipsec ipv6 statistics Displays IPsec statistics for IPv6 traffic.
To Next Page
Loading...
