Configuring QoS QoS Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 26-35
Policy Rule Defaults
The following are defaults for the policy rule command:
Policy Action Defaults
The following are defaults for the policy action command:
Note that in the current software release, the deny and drop options produce the same effect that is, the
traffic is silently dropped.
Description Keyword Default
Policy rule enabled or disabled enable | disable enabled
Determines the order in which
rules are searched
precedence 0
Whether the rule is saved to
flash immediately
save yes
Whether messages about flows
that match the rule are logged
log no
How often to check for matching
flow messages
log interval 60 seconds
Whether to count bytes or
packets that match the rule.
count packets
Whether to send a trap for the
rule.
trap yes (trap sent only on port disable
action or UserPort shutdown
operation)
Whether the rule is saved to the
default list
default-list yes (all policy rules belong to the
default list unless otherwise
specified at the time the rule is
created)
Description Keyword Default
Whether the flow matching the
rule must be accepted or denied
disposition accept
Tri-Color Marking (TCM) mode
- committed rate and burst size
- peak rate and burst size
cir cbs
pir pbs
Single-rate TCM (srTCM) mode
CIR=0, CBS=10K
PIR=0, PBS=10K
Note. There are no defaults for the policy condition command.
To Next Page
Loading...
