Configuring BFD Verifying the BFD Configuration
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 20-39
Verifying the BFD Configuration
To display information such as the BFD status for different session parameters and Layer 3 protocols, use
the show commands listed in the following table:
For more information about the resulting displays form these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide. Examples of the above commands and their outputs are given in the
section “Configuring BFD” on page 20-14.
show ip bfd Displays the global BFD configuration for the routing instance.
show ip|ipv6 bfd interfaces Displays the BFD interface configuration for the switch.
show ip|ipv6 bfd sessions Displays the BFD neighbors and session states.
show ip bgp Displays the BFD status for the BGP protocol.
show ip bgp neighbors Displays the BFD status for IPv4 BGP neighbors.
show ipv6 bgp neighbors Displays the BFD status for IPv6 BGP neighbors.
show ip isis status Displays the BFD status for the IS-IS protocol.
show ip isis vlan Displays the BFD status for IS-IS VLANs.
show ip ospf Displays the BFD status for the OSPF protocol.
show ip ospf interface Displays the BFD status for OSPF interfaces.
show ipv6 ospf Displays the BFD status for the OSPFv3 protocol.
show ipv6 ospf interface Displays the BFD status for OSPFv3 interfaces.
show ip pim sparse
show ip pim dense
Displays the BFD status for the IPv4 PIM.
show ipv6 pim sparse
show ipv6 pim dense
Displays the BFD status for the IPv6 PIM.
show ip pim interface Displays the BFD status for the IPv4 PIM interface.
show ipv6 pim interface Displays the BFD status for the IPv6 PIM interface.
show vrrp|vrrp3 Displays the BFD status for the VRRP and VRRP3 protocol.
show vrrp track Displays the BFD status for a track policy.
show ip router database
protocol static
Displays the BFD status for IPv4 static routes.
show ipv6 router database Displays the BFD status for IPv6 static routes.
To Next Page
Loading...
