Configuring Ethernet OAM Ethernet OAM Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 37-2
Ethernet OAM Defaults
The following table shows Ethernet OAM default values.
Parameter Description Command Default Value/Comments
MHF value assigned to a MD ethoam domain mhf none
ID-permission value for MD entry ethoam domain id-permission none
MHF value assigned to a MA ethoam association mhf defer
Continuity Check Message interval
for the MA
ethoam association ccm-
interval
10 seconds
Default domain level ethoam default-domain level 0
Default domain MHF value ethoam default-domain mhf none
Default domain ID permission ethoam default-domain id-
permission
none
The administrative status of the MEP ethoam endpoint admin-state disable
The priority value for CCMs and
LTMs transmitted by the MEP
ethoam endpoint priority 7
The lowest priority fault alarm for
the lowest priority defect for a MEP
ethoam endpoint lowest-
priority-defect
mac-rem-err-xcon
Number of Loopback messages ethoam loopback 1
Fault notification generation reset
time
ethoam fault-reset-time 1000 centiseconds
To Next Page
Loading...
