Configuring IP Multicast Switching Modifying IPMSv6 Parameters
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 25-40
To configure a static source IPv6 address for a specific VLAN or SPB service, use the ipv6 multicast
spoofing command with the vlan and static-source-ip parameters. For example:
-> ipv6 multicast vlan 2 spoofing static-source-ip 3333::1
-> ipv6 multicast service 10 spoofing static-source-ip 333::1
To remove a static source IPv6 address for the system or a specific VLAN or SPB service, use the no form
of the ipv6 multicast spoofing command. For example:
-> no ipv6 multicast spoofing static-source-ip
-> no ipv6 multicast vlan 2 spoofing static-source-ip
-> no ipv6 multicast service 10 spoofing static-source-ip
Disabling MLD Spoofing
To disable MLD spoofing on the system if no VLAN or SPB service is specified, you use the ipv6
multicast spoofing command as shown below:
-> ipv6 multicast spoofing disable
Or, as an alternative, enter the following command to restore the MLD spoofing to its default setting:
-> no ipv6 multicast spoofing
You can also disable MLD spoofing on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 spoofing disable
-> ipv6 multicast service 10 spoofing disable
Or, as an alternative, enter the following command to restore the MLD spoofing to its default setting:
-> no ipv6 multicast vlan 2 spoofing
-> no ipv6 multicast service 10 spoofing
Enabling and Disabling the MLD Zapping
By default MLD (i.e., processing membership and source filter removals immediately without waiting for
the specified time period for the protocol– this mode facilitates IP TV applications looking for quick
changes between IP multicast groups.) is disabled on a switch. The following subsections describe how to
enable and disable zapping by using the ipv6 multicast zapping command.
Enabling the MLD Zapping
To enable MLD zapping on the system if no VLAN or SPB service is specified, use the ipv6 multicast
zapping command as shown below:
-> ipv6 multicast zapping enable
You can also enable MLD zapping on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 zapping enable
-> ipv6 multicast service 10 zapping enable
To Next Page
Loading...
