Configuring Dynamic Link Aggregation Configuring Dynamic Link Aggregate Groups
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 9-10
For example, to configure actor administrative key of 10, a local system ID (MAC address) of
00:20:da:06:ba:d3, and a local priority of 65535 to slot 4 port 1, enter:
-> linkagg lacp port 4/1 actor admin-key 10 actor system-id 00:20:da:06:ba:d3
actor system-priority 65535
For example, to configure an actor administrative key of 10 to slot 4 port 1, enter:
-> linkagg lacp port 4/1 actor admin-key 10
Removing Ports from a Dynamic Aggregate Group
To remove a port from a dynamic aggregate group, use the no form of the linkagg lacp agg actor admin-
key command by entering linkagg lacp port followed by the slot number, a slash (/), and the port number.
For example, to remove port 4 in slot 4 from any dynamic aggregate group, enter:
-> no linkagg lacp port 4/4
Ports must be deleted in the reverse order in which they were configured. For example, if port 4/4 through
4/6 were configured to join dynamic aggregate group 2 you must first delete port 4/6, then port 4/5, and so
forth. The following is an example of how to delete ports in the proper sequence from the console:
-> no linkagg lacp port 4/6
-> no linkagg lacp port 4/5
-> no linkagg lacp port 4/4
To Next Page
Loading...
