Alcatel-Lucent OmniSwitch 6860 Series User Manual

Configuring IP Multicast Switching IPMSv6 Application Example
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 25-44
IPMSv6 Application Example
The figure below shows a sample network with the switch sending multicast video. A client attached to
Port 5 needs to be configured as a static MLD neighbor and another client attached to Port 2 needs to be
configured as a static MLD querier.
Example IPMS Network
The network administrator has determined that the network is too lossy and therefore the robustness
variable needs to be set to a higher (i.e., 7) value.
Follow the steps below to configure this network:
1 Enable IP Multicast Switching and Routing switch-wide, by entering:
-> ipv6 multicast admin-state enable
2 Configure the client attached to Port 5 as a static MLD neighbor belonging to VLAN 5 by entering:
-> ipv6 multicast static-neighbor vlan 5 port 1/5
3 Configure the client attached to Port 2 as a static MLD querier belonging to VLAN 5 by entering:
-> ipv6 multicast static-querier vlan 5 port 1/2
4 Modify the robustness variable from its default value of 2 to 7 by entering:
-> ipv6 multicast robustness 7
Note. All the steps following Step 1 (which must be executed first) can be entered in any order.
OmniSwitch
Multicast Server
(source IPv6 address)
Static Neighbor
Attached to Slot 1, Port 5.
Static Querier
Attached to Slot 1, Port 2.
Video
Network Clients
Network clients send MLD
requests to receive multicast
traffic.

Alcatel-Lucent OmniSwitch 6860 Series Specifications

General

Model	OmniSwitch 6860 Series
Category	Switch
Maximum Ports	48
Switching Capacity	Up to 176 Gbps
Operating System	AOS (Alcatel-Lucent Operating System)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Relative Humidity	5% to 95% non-condensing
Port Types	10/100/1000BASE-T, SFP+, QSFP+
Ports	24, 48
Power over Ethernet (PoE)	Yes
Stacking	Yes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Form Factor	1U rack-mountable
MAC Address Table Size	32, 000
Jumbo Frame Support	Yes
Dimensions (W x D x H)	440 mm x 420 mm x 44 mm (17.3 in x 16.5 in x 1.73 in)
Power Supply	AC or DC (depending on model)
Power Consumption	Varies by model and configuration