Configuring ERP ERP Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 11-2
ERP Defaults
ERP default settings:
ERPv2 default settings:
Parameter Description Command Default
ERP ring status erp-ring Disabled
RPL status for the node erp-ring rpl-node Disabled
The wait-to-restore timer value for
the RPL node
erp-ring wait-to-restore 5 minutes
The guard-timer value for the ring
node
erp-ring guard-timer 50 centi-seconds
The NNI-SVLAN association type ethernet-service svlan nni STP
The Ethernet Ring Protection (ERP)
Ring Virtual Channel.
erp-ring virtual-channel Enabled
Revertive mode on a specified node. erp-ring revertive Enabled
To Next Page
Loading...
