Configuring Loopback Detection Interaction With Other Features
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 7-6
Interaction With Other Features
This section contains important information about how other OmniSwitch features interact with LBD.
Refer to the specific chapter for each feature to get more detailed information about how to configure and
use the feature.
Spanning Tree Protocol
• If the STP mode is set to Multiple Spanning Tree, Loopback Detection can only be enabled on
interfaces where STP is disabled.
• LBD frame are sent untagged regardless of the spanning tree state on the port.
Link Aggregation
When loopback is detected on any one of the Linkagg port, all the ports of the linkagg will be shutdown
due to loopback detection.
To Next Page
Loading...
