Configuring IP Multicast Switching Configuring IPMSv6 on a Switch
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 25-29
Enabling and Disabling MLD Querier-forwarding
By default, MLD querier-forwarding is disabled.The following subsections describe how to enable and
disable MLD querier-forwarding by using the ipv6 multicast querier-forwarding command.
Enabling the MLD Querier-forwarding
You can enable the MLD querier-forwarding by entering ipv6 multicast querier-forwarding followed by
the enable keyword. For example, to enable the MLD querier-forwarding on the system if no VLAN or
SPB service is specified, you would enter:
-> ipv6 multicast querier-forwarding enable
You can also enable the MLD querier-forwarding on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 querier-forwarding enable
-> ipv6 multicast service 10 querier-forwarding enable
Disabling the MLD Querier-forwarding
You can disable MLD querier-forwarding by entering ipv6 multicast querier-forwarding followed by
the disable keyword. For example, to disable MLD querier-forwarding on the system if no VLAN or SPB
service is specified, you would enter:
-> ipv6 multicast querier-forwarding disable
Or, as an alternative, enter the following command to restore MLD querier-forwarding to its default
setting:
-> no ipv6 multicast querier-forwarding
You can also disable MLD querier-forwarding on the specified VLAN or SPB service by entering:
-> ipv6 multicast vlan 2 querier-forwarding disable
-> ipv6 multicast service 10 querier-forwarding disable
Or, as an alternative, enter the following commands to restore MLD querier-forwarding to its default
setting:
-> no ipv6 multicast vlan 2 querier-forwarding
-> no ipv6 multicast service 10 querier-forwarding
Configuring and Restoring the MLD Version
By default, the version of Multicast Listener Discovery (MLD) Protocol is Version 1. The following
subsections describe how to configure the MLD version as Version 1 or Version 2 by using the ipv6
multicast version command.
Configuring the MLD Version 2
To change the MLD version to Version 2 (MLDv2) on the system if no VLAN or SPB service is specified,
use the ipv6 multicast version command as shown below:
-> ipv6 multicast version 2
To Next Page
Loading...
