Configuring BFD BFD Application Example
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 20-38
Step 8: Examine the Network
After the network has been created, use the following show commands to check various aspects of the
example network:
• To verify the configured BFD status on routers, use the show ip bfd command. This command shows
the protocols registered for BFD (OSPF in example network) and the parameter values for the transmit,
receive, and echo intervals, the multiplier number, and the operational mode.
• To display information about BFD sessions, use the show ip|ipv6 bfd sessions command.
• To check the BFD status at the OSPF protocol level, use the show ip ospf command. This command is
also used to check the general OSPF configuration. For OSPF interfaces, use the show ip ospf
interface command.
To Next Page
Loading...
