Configuring High Availability VLANs Application Examples
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 5-15
An example of what these commands look like entered sequentially on the command line:
-> server-cluster 3 mode L3 admin-state enable
-> vlan 12
-> vlan 12 members port 1/3 untagged
-> vlan 12 members port 1/4 untagged
-> vlan 12 members port 1/5 untagged
-> server-cluster 3 port 1/3
-> server-cluster 3 port 1/4
-> server-cluster 3 port 1/5
-> server-cluster 3 ip 10.135.33.12 mac-address static 01:00:11:22:33:44
-> ip multicast admin-state enable
-> server-cluster 3 igmp-mode enable
-> server-cluster 3 ip-multicast 225.0.0.23
Note. In order to process IGMP reports, it is required to enable IP mulitcast by using the ip multicast
admin-state enable command.
To Next Page
Loading...
