Configuring Dynamic Link Aggregation Modifying Dynamic Link Aggregate Group Parameters
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 9-24
For example, to modify the port priority of dynamic aggregate partner port 3 in slot 4 to 100, enter:
-> linkagg lacp port 4/3 partner admin-port priority 100
Restoring the Partner Port Priority
To remove a user-configured partner port priority from a dynamic aggregate group partner port
configuration use the no form of the linkagg lacp port partner admin port-priority command by
entering no linkagg lacp port, the slot number, a slash (/), the port number, partner admin-port
priority.
For example, to remove a user-configured partner port priority from dynamic aggregate partner port 3 in
slot 4 you would enter:
-> no linkagg lacp port 4/3 partner admin-port priority
To Next Page
Loading...
