Configuring 802.1AB Configuring 802.1AB
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 13-11
To disable the Proprietary TLV on a switch, enter the ldp tlv proprietary command, as shown:
-> lldp chassis tlv proprietary disable
To disable Proprietary TLV on port, for example port 3 of slot 4, enter the following command at the CLI
prompt:
-> lldp port 1/4/4 tlv proprietary disable
To view the operational status of Proprietary TLV on a switch, use the show lldp config command.
To view the AP location, use the show lldp local-port command.
-> show lldp local-port
Local Slot 1/Port 1 LLDP Info:
Port ID = 1001 (Locally assigned),
Port Description = Alcatel-Lucent 1/1,
Vlan = 1,
AP Location = sw1,
Local Slot 1/Port 2 LLDP Info:
Port ID = 1002 (Locally assigned),
Port Description = Alcatel-Lucent 1/2,
Vlan = 1,
AP Location = -,
The AP location and VLAN information can also be viewed from WebView. To view the information,
from the WebView page:
1 Click on the Physical tab.
2 Click on Adjacencies. Adjacencies home page is displayed.
3 In the Adjacencies home page, select LLDP.
4 Click on Local and select AP Management TLV from the displayed option. This will display the AP
Management TLV information such as Slot, Port, VLAN, and AP Location. A sample screen is displayed
as follows:
To Next Page
Loading...
