Configuring IPv6 IPv6 Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 17-2
IPv6 Defaults
The following table lists the defaults for IPv6 configuration through the ip command.
Description Command Default
Global status of IPv6 on the
switch
N/A Enabled
Interfaces ipv6 interface loopback
6to4 tunnels ipv6 interface tunnel_6to4
Prefixes ipv6 prefix None
Hop Limit ipv6 hop-limit 64
Path MTU entry minimum
lifetime
ipv6 pmtu-lifetime 10 minutes
Neighbor stale lifetime ipv6 neighbor stale-lifetime 10 minutes
Local Unicast Global ID ipv6 address global-id None
To Next Page
Loading...
