Alcatel-Lucent OmniSwitch 6860 Series

Configuring IPv6 IPv6 EMP Interface
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 17-30
To Configure IPv6 EMP interface, configure the IP address and mask:
Boot > boot empipv6masklength 64
Boot > show
EMP IP Address : 10.200.105.21/24
Serial (console) baud : 9600
Serial (console) parity : none
Serial (console) wordsize : 8
Serial (console) stopbits : 1
Serial (console) mode : modemControlOff
EMP IPV6 Address : /64
Boot > boot empipv6addr 2001::205
Boot > show
EMP IP Address : 10.200.105.21/24
Serial (console) baud : 9600
Serial (console) parity : none
Serial (console) wordsize : 8
Serial (console) stopbits : 1
Serial (console) mode : modemControlOff
EMP IPV6 Address : 2001::205/64
Boot >
Use the show ipv6 interface and show ipv6 emp-interface commands to view the EMP interface
configuration. The show ipv6 emp-routes command displays the IPv6 routes targeted to EMP port/IPv6
EMP interface configuration.