Configuring IPsec Configuring IPsec on the OmniSwitch
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 18-18
Once IPsec is configured for IPv6 on the switch, you can monitor the incoming and outgoing packets for
the configured parameters by using the show ipsec ipv6 statistics command.
-> show ipsec ipv6 statistics
Inbound:
Successful = 2787
Policy violation = 0
No SA found = 0
Unknown SPI = 0
AH replay check failed = 0
ESP replay check failed = 0
AH authentication success = 93
AH authentication failure = 0
ESP authentication success = 25
ESP authentication failure = 0
Packet not valid = 0
No memory available = 0
Outbound:
Successful = 5135
Policy violation = 0
No SA found = 19
Packet not valid = 0
No memory available = 0
To Next Page
Loading...
