Configuring RIP Configuring Redistribution
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 19-16
RIP routes received by the router interface are processed based on the contents of the ospf-to-rip route
map. Routes that match criteria specified in this route map are either allowed or denied redistribution into
the RIP network. The route map can also specify the modification of route information before the route is
redistributed. See “Using Route Maps” on page 19-12 for more information.
To remove a route map redistribution configuration, use the no form of the ip redist command. For
example:
-> no ipv6 redist ospf into rip route-map ospf-to-rip
Use the show ip redist command to verify the redistribution configuration:
-> show ip redist
Source Destination
Protocol Protocol Status Route Map
------------+------------+---------+--------------------
LOCAL4 RIP Enabled rip_1
LOCAL4 OSPF Enabled ospf_2
LOCAL4 BGP Enabled bgp_3
RIP OSPF Enabled ospf-to-rip
Configuring the Administrative Status of the Route Map Redistribution
The administrative status of a route map redistribution configuration is enabled by default. To change the
administrative status, use the status parameter with the ip redist command. For example, the following
command disables the redistribution administrative status for the specified route map:
-> ip redist ospf into rip route-map ospf-to-rip admin-state disable
The following command example enables the administrative status:
-> ip redist ospf into rip route-map ospf-to-rip admin-state enable
To Next Page
Loading...
