Configuring BFD BFD Defaults
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 20-3
BFD session status with all OSPF or
OSPFv3 neighbors of the
corresponding interface which are
greater than or equal to “2-way” state
ip ospf interface bfd-state all-
neighbors
ipv6 ospf interface bfd-state all-
neighbors
Enabled
BFD status for the IPv4 or IPv6 PIM
protocol
ip pim bfd-state
ipv6 pim bfd-state
Disabled
BFD status for an IPv4 or IPv6 PIM
interface.
ip pim interface bfd-state
ipv6 pim interface bfd-state
Disabled
BFD status for an IPv4 or IPv6 static
route.
ip static-route bfd-state
ipv6 static-route bfd-state
Enabled
BFD status for VRRP protocol vrrp bfd-state Disabled
BFD status for a VRRP tracking
policy.
vrrp track Enabled
Parameter Description Command Default Value/Comments
To Next Page
Loading...
