Configuring BFD BFD Application Example
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 20-36
Step 4: Configure OSPF Interfaces
Next, OSPF interfaces must be created, enabled, and assigned to area 0.0.0.1. The OSPF interfaces should
have the same interface name as the IP router interfaces created above in “Step 1: Prepare the Routers” on
page 20-34.
Router 1
-> ip ospf interface vlan-31
-> ip ospf interface vlan-31 area 0.0.0.0
-> ip ospf interface vlan-31 admin-state enable
-> ip ospf interface vlan-12
-> ip ospf interface vlan-12 area 0.0.0.0
-> ip ospf interface vlan-12 admin-state enable
-> ip ospf interface vlan-10
-> ip ospf interface vlan-10 area 0.0.0.1
-> ip ospf interface vlan-10 admin-state enable
Router 2
-> ip ospf interface vlan-12
-> ip ospf interface vlan-12 area 0.0.0.0
-> ip ospf interface vlan-12 admin-state enable
-> ip ospf interface vlan-23
-> ip ospf interface vlan-23 area 0.0.0.0
-> ip ospf interface vlan-23 admin-state enable
-> ip ospf interface vlan-20
-> ip ospf interface vlan-20 area 0.0.0.2
-> ip ospf interface vlan-20 admin-state enable
Router 3
-> ip ospf interface vlan-23
-> ip ospf interface vlan-23 area 0.0.0.0
-> ip ospf interface vlan-23 admin-state enable
-> ip ospf interface vlan-31
-> ip ospf interface vlan-31 area 0.0.0.0
-> ip ospf interface vlan-31 admin-state enable
-> ip ospf interface vlan-30
-> ip ospf interface vlan-30 area 0.0.0.3
-> ip ospf interface vlan-30 admin-state enable
Step 5: (Optional) Configure BFD Interfaces
Next, BFD interfaces must be created and enabled. The BFD interfaces should have the same interface
name as the IP router interfaces created above in “Step 1: Prepare the Routers” on page 20-34.
Router 1
-> ip bfd interface vlan-31
-> ip bfd interface vlan-31 admin-state enable
-> ip bfd interface vlan-12
-> ip bfd interface vlan-12 admin-state enable
To Next Page
Loading...
