Configuring an Internal DHCP Server Configuration File Parameters and Syntax
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 22-22
72 dhcp-www-
server
option dhcp-
www-server
10.10.0.100;
ip_address_
list
N/A Specifies a list of WWW servers
available to the client. Servers should
be listed in order of preference.
73 dhcp-finger-
server
option dhcp-
finger-server
10.10.0.100;
ip_address_
list
N/A Specifies a list of Finger servers
available to the client. Servers should
be listed in order of preference.
74 dhcp-irc-server
option dhcp-
irc-server
10.10.0.100;
ip_address_
list
N/A Specifies a list of IRC servers
available to the client. Servers should
be listed in order of preference.
75 dhcp-streettalk-
server
option dhcp-
streetalk-
server
10.10.0.100;
ip_address_
list
N/A Specifies a list of StreetTalk servers
available to the client. Servers should
be listed in order of preference.
76 dhcp-stda-
server
option dhcp-
stda-server
10.10.0.100;
ip_address_
list
N/A Specifies a list of STDA (StreetTalk
Directory Assistance) servers
available to the client. Servers should
be listed in order of preference.
78 slp-directory-
agent
option slp-
directory-agent
[000a0a0064];
sub-option Specifies the location of one or more
SLP Directory Agents. The SLP
Directory Agent option contains the
following suboptions:
Mandatory boolean False This sub-option may be set to either
True or False. If it is set to True, the
SLP UserAgent or Service Agent so
configured must not employ either
active or passive multicast discovery
of Directory Agents.
Directory
Agent Address
ip_address_
list
N/A This sub-option allows a IP address
list to be specified. The list must be
in order of preference, if an order of
preference is desired.
79 slp-service-
scope
option slp-
service-scope
[0078797a];
sub-option Specifies the scopes that a SLP
Agent is configured to use. It
contains the following suboptions:
If set to False, static configuration
takes precedence over the DHCP
provided scope list.
If set to True, the entries in the
Scope List must be used by the SLP
Agent.
Scope Listtext N/A This sub-option is a comma-
delimited list of scopes. The list is
case insensitive.
Option
Code
dhcpd.conf
Key-word
dhcpd.conf
example
Data type
Default
Value
Description
To Next Page
Loading...
