Alcatel-Lucent OmniSwitch 6860 Series

Configuring an Internal DHCP Server Configuration File Parameters and Syntax
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 22-24
116 ipv4-auto-
configuration
option ipv4-
auto-
configuration
false;
boolean False This option is used to check whether,
and be notified if, autoconfiguration
should be disabled on the local
subnet. When a server responds with
the value “AutoConfigure” (True),
the client may generate a linklocal IP
address if appropriate. However, if
the server responds with
“DoNotAutoConfigure” (False), the
client must not generate a link-local
IP address, possibly leaving it with
no IP address.
119 domain-search
option domain-
search
[0378797a00];
text_list N/A Passes the domains in the search list
from the DHCP Server to the DHCP
Client to use when resolving
hostnames using DNS.
120 sip-server
option sip-
server
[010a0a0064];
ip_address_
list
N/A Lists the SIP servers specified as
IPV4
121 classless-static-
route
option
classless-
static-route
16.10.10
10.10.0.200;
ip_mask_ip
_list
N/A Specifies one or more static routes,
each of which consists of a
destination descriptor (the subnet
address and subnet mask) and the IP
address of the router that should be
used to reach that destination.
122 cablelabs-
client-config
option
cablelabs-
client-config
[01040a0a006402
040a0a0064040
c0000000a000000
0a0000000a050
c0000000a000000
0a0000000a060
50358595a000701
00080100];
option 177
[010378797a0203
78797a030378797
a040378797a0503
78797a060378797
a07010008010009
0378797a];
sub_option The following table describes the
CableLabs Client Configuration 122
sub-options, specified in RFC 3495:
Option
Code
dhcpd.conf
Key-word
dhcpd.conf
example
Data type
Default
Value
Description