Alcatel-Lucent OmniSwitch 6860 Series

Configuring Access Guardian Configuring Port-Based Network Access Control
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-56
-> show vlan 450
Name : UNP-DYN-VLAN,
Type : UNP Dynamic Vlan,
Administrative State : enabled,
Operational State : disabled,
IP Router Port : disabled,
IP MTU : 1500
• Dynamic VLANs are not saved in the “! VLAN:” section of the switch configuration file (boot.cfg).
However, the unp commands to enable dynamic VLAN configuration and create the UNP are saved in
the “! DA-UNP:” section of boot.cfg (see the following sample boot.cfg file). As a result, the VLAN is
created again on the next switch bootup.
-> show configuration snapshot vlan
! VLAN:
vlan 1 admin-state enable
vlan 451 admin-state enable
vlan 777 admin-state enable
vlan 887-888 admin-state enable
-> show configuration snapshot da
! DA-UNP:
unp dynamic-vlan-configuration enable
unp profile “temp1”
unp profile “unpTemp”
unp profile “unpTemp2”
unp profile “temp1” map vlan 450
unp profile “unpTemp” map vlan 10
unp profile “unpTemp2” map vlan 10
unp classification mac-address 00:00:00:00:00:01 profile1 unpTemp2
unp classification mac-address 10:22:33:44:55:66 profile1 unpTemp2
unp classification ip-address 1.1.1.2 mask 255.0.0.0 profile1 unpTemp2
unp port 1/1/11 port-type bridge
unp port 1/1/11 802.1x-authentication
unp port 1/1/11 classification
unp port 1/1/12 port-type bridge
unp port 1/1/12 mac-authentication
unp port 1/1/12 classification
To verify the status of dynamic VLAN configuration for the switch, use the show unp global
configuration command. For example:
-> show unp global configuration
Dynamic Vlan Configuration = Enabled,
Dynamic Profile Configuration = Disabled,
Auth Server Down Profile1 = -,
Auth Server Down Profile2 = -,
Auth Server Down Profile3 = -,
Auth Server Down Timeout = 60,
Redirect Port Bounce = Enabled,
Redirect Pause Timer = -
Redirect http proxy-port = 8080
Redirect Server IP = 10.1.1.1
Allowed IP = -
Force L3-Learning = Disabled
Force L3-Learning Port Bounce = Disabled
802.1x Pass Through Mode = Disabled
AP Mode = Enabled