Configuring Access Guardian Configuring Port-Based Network Access Control
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 28-64
• The name of an existing QoS policy list.
To configure a user-defined role, use the unp user-role command. For example:
-> unp user-role role1 precedence 10
-> unp user-role role1 policy-list role1-list
-> unp user-role role1 profile1 unp1-vlan profile2 unp2-spb
-> unp user-role role1 authentication-type 8021x
-> unp user-role role1 cp-status-post-login
Use the show unp user-role command to display the user-defined role configuration. For example:
-> show unp user-role
Role Name: role1
Qos Policy List : role1-list
Priority : 10
Conditions:
Profile1 : unp1-vlan
Profile2 : unp2-spb
Profile3 : -
Authentication-Type : 802.1x
CP Status : Enabled
Role Name: role2
Qos Policy List : qlist-allow
Priority : 1
Conditions:
Profile1 : -
Profile2 : -
Profile3 : -
Authentication-Type : 802.1x Fail
CP Status : Disabled
Total User Role Derivation Rule Count: 2
To Next Page
Loading...
