Configuring Application Monitoring and Enforcement Configuring AppMon
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 29-12
Captive-Portal Status = -,
QMR Status = Passed,
Redirect Url = -,
SIP Call Type = Not in a call,
SIP Media Type = None,
Applications = whatsapp
Total users : 1
• For QoS policies, AppMon can be enabled on any OmniSwitch 6860 or OmniSwitch 6860E element of
the network for enforcing policy actions such as drop, 802.1p/DSCP priority marking, and rate
limiting. Only the edge switches need to enable AppMon enforcement functionality for higher priority
QoS treatment. Intermediate switches in the network must only provide consistent QoS treatment based
on the earlier marking done by edge switches, whereas core switches only provide QoS treatment.
• AppMon enforcement configures both ingress/egress flow tracking configuration on each port when
enabled. If both ports are disabled for a given flow, flow is not tracked and QoS treatment is not given.
• To upgrade an OmniSwitch from an 8.1.1 image to an 8.2.1 image, remove the existing AppMon
configuration and use the write memory command. After a successful upload of an 8.2.1 image,
configure the required AppMon settings.
To Next Page
Loading...
