Configuring VLANs Assigning Ports to VLANs
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 4-8
Port 4/3 is now configured to carry packets tagged with VLAN 5, even though VLAN 5 is not the default
VLAN for the port.
To enable tagging on link aggregation groups, enter the link aggregation group identification number in
place of the slot and port number, as shown:
-> vlan 5 members linkagg 8 tagged
(For further information on creating link aggregation groups, see Chapter 8, “Configuring Static Link
Aggregation,” or Chapter 9, “Configuring Dynamic Link Aggregation.”)
To remove 802.1Q tagging from a selected port or link aggregate, use the untagged parameter.
-> vlan 5 members linkagg 8 untagged
To display all VLANs, enter the following command:
-> show vlan port
Note. The link aggregation group must be created first before it can be set to use 802.1Q tagging.
To Next Page
Loading...
