Configuring Application Fingerprinting Configuring AFP
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 30-17
Verifying the AFP Mode Configuration
The QoS and UNP modes both specify application groups for AFP processing. This difference is that the
QoS mode directly associates a policy list name with the AFP port, but the UNP mode uses a policy list
assigned to a UNP associated with traffic received on the AFP port. The monitoring mode does just that,
monitors application group traffic, but does not apply any QoS.
To verify the AFP port configuration for the switch, use the show app-fingerprint port command. For
example:
-> show app-fingerprint port
Legend: * = Port or App-Group is invalid
Port Operation Mode App-group/Policy-list
--------+----------------+----------------------------------------
1/2/1 Monitoring Testing13
1/2/1 QoS list1
1/2/1 QoS list2
-> show app-fingerprint linkagg
Legend: * = Port or App-Group is invalid
Port Operation Mode App-group/Policy-list
--------+----------------+----------------------------------------
0/100 Monitoring Testing16
0/100 QoS list3
0/100 QoS list4
To Next Page
Loading...
