Diagnosing Switch Problems In This Chapter
OmniSwitch AOS Release 8 Network Configuration Guide December 2017 page 34-2
• Disabling a Port Monitoring Session—see “Disabling a Port Monitoring Session” on page 34-19.
• Deleting a Port Monitoring Session—see “Deleting a Port Monitoring Session” on page 34-19.
• Pausing a Port Monitoring Session—see “Pausing a Port Monitoring Session” on page 34-20.
• Configuring the persistence of a Port Monitoring Session—see “Configuring Port Monitoring Session
Persistence” on page 34-20.
• Configuring a Port Monitoring data file—see “Configuring a Port Monitoring Data File” on
page 34-20.
• Configuring a Port Monitoring direction—see “Configuring Port Monitoring Direction” on page 34-21.
• Configuring capture-type—see “Configuring the Capture Type” on page 34-22.
• Displaying Port Monitoring Status and Data—see “Displaying Port Monitoring Status and Data” on
page 34-22.
• Configuring a sFlow Session—see “Configuring a sFlow Session” on page 34-24.
• Configuring a Fixed Primary Address—see “Configuring a Fixed Primary Address” on page 34-25.
• Displaying a sFlow Receiver—see “Displaying a sFlow Receiver” on page 34-25.
• Displaying a sFlow Sampler—see “Displaying a sFlow Sampler” on page 34-26.
• Displaying a sFlow Poller—see “Displaying a sFlow Poller” on page 34-26.
• Displaying a sFlow Agent—see “Displaying a sFlow Agent” on page 34-27.
• Deleting a sFlow Session—see “Deleting a sFlow Session” on page 34-27.
• Enabling or Disabling RMON Probes—see “Enabling or Disabling RMON Probes” on page 34-30.
• Configuring Resource Threshold Limits (Switch Health)—see “Configuring Resource Thresholds” on
page 34-36.
• Configuring Sampling Intervals—see “Configuring Sampling Intervals” on page 34-38.
For information about additional Diagnostics features such as Switch Logging and System Debugging/
Memory Management commands, see Chapter 36, “Using Switch Logging.”
To Next Page
Loading...
