Backup Services Commands
Page 34-8
: 30=3
: 31=3
: 32=32
: 40=1
: ?
1) Description : Backup 2
2) Admin Status { (E)nabled, (D)isabled } : Enabled
3) Primary Type { Physical Port (1),
Frame Relay PVC (2) } Physical Port
30) Slot : 3
31) Port : 3
32) DLCI : 32
4) Backup Type { PPP Peer (1) } : PPP Peer
40) Peer ID : 1
5) Startup Timer Value { Time in Seconds after
System Startup to wait
for Primary to come up
before activating
Backup } : 300
6) Activate Timer Value { Time in Seconds after
Primary Failure to
activate Backup } : 10
7) Restore Timer Value { Time in Seconds after
Primary restoral to
disable Backup } : 10
(save/quit/cancel)
:
Once you are satisfied with the values, enter the save command, followed by <return>:
: save <return>
A screen similar to that shown below will display:
Backup Service Index 2 created.
/Interface/backup %
To Next Page
Loading...
