S331L UG PN: 10580-00321 Rev. M 1-5
General Information 1-2 Instrument Description
Battery Information
The batteries that are supplied with the Site Master may need charging
before use. They can be charged using either the AC-DC Adapter or the
DC adapter. Refer to “Status Tool Bar” on page 2-17 for a description of
battery symbols. The batteries are charged in the instrument and only
removed for replacement.
The Site Master batteries are installed at the factory and can be
replaced by the user. Refer to Chapter 10, “Battery Replacement” for
information on replacing the batteries. The batteries are charged with
the included AC/DC adapter.
Note
Use only Anritsu-approved batteries, adapters, and chargers
with this instrument.
The batteries will charge at a faster rate when the instrument
is turned off or is set to standby mode. Charging the batteries
while the instrument is running will take a longer time to reach
a full charge.
To prolong the useful battery life, the internal charging circuit
monitors each battery’s temperature. Normal charging occurs
when the battery temperature is between 0 °C and 45 °C.
Charging is paused if the internal battery temperature is
beyond this range.
Caution
When using the Automotive Cigarette Lighter Adapter, always
verify that the supply is rated for a minimum of 40 Watts @
12 VDC, and that the socket is clear of any dirt or debris. If
the adapter plug becomes hot to the touch during operation,
discontinue use immediately.
Note
Anritsu Company recommends removing the battery for
long-term storage of the instrument.
To Next Page
Loading...
Need help?
General
