A-2 PN: 10580-00321 Rev. M S331L UG
A-1 Introduction Instrument Messages
8. Error executing remote command: The remote command sent to
the instrument has generated an unexpected error. Perform a
Factory Reset and then cycle the power to the instrument. If error
message persists, call your Anritsu Service Center.
9. Error executing remote query command: The remote query
command sent to the instrument has generated an unexpected
error. Perform a Factory Reset and then cycle the power to the
instrument. If error message persists, call your Anritsu Service
Center.
10. Error occurred while zeroing. Please zero sensor without
RF input: When zeroing a USB power sensor, the RF input
connector of the sensor must not be connected to any source of
RF power. If RF power is detected during the zeroing, the
calibration will fail and the zeroing will not be applied.
11. File cannot be recalled: File being recalled failed because the
instrument model used when the file was saved does not match
the current instrument model.
12. File missing: File being accessed cannot be found. The file has
either been deleted or moved to a different location.
13. Forward relative not applicable: For the USB In-line power
sensor, relative readings do not apply when making forward
measurements of CCDF.
14. Hardware driver failed to load: One of the hardware drivers
required has not loaded correctly. Perform a Factory Reset and
then cycle the power to the instrument. If error message persists,
call your Anritsu Service Center.
15. Instacal - Power Meter Hardware not detected: Error detecting
Instacal/Power Meter module. Turn off the power to the
instrument. Check that the hardware is installed correctly and
then re-start the instrument. If error message persists, call your
Anritsu Service Center.
16. InstaCal Characterization data corrupted: Time Stamp:
Characterization data stored in the InstaCal module has been
corrupted. Perform a Factory Reset and then cycle the power to
the instrument. If error message persists, call your Anritsu
Service Center.
To Next Page
Loading...
Need help?
General
