Ateis IDA8 Series User Manual

System Configuration 257
© 2020, ATEÏS. All rights reserved.
5.3.6 Step Control
This event is used for controlling the element value. It will adjust the element value by step when the
source triggers the event. The source which triggers the event will send the step value to the event for
adjusting elements.
Click [Add] to create a new event, and a pop-up setting
window will be displayed, here you can choose which
kinds of event users acquired. Select [Step Control]
option on [Type] drop-down box, then press [OK].
Event Settings
After creating a Step Control event, users
need to assign an element to it.
1. Right click the desired element, and click
the options [Event > Step Control > XXX]
which XXX is the name of the event. See
the picture on the right.
2. Click [Content...] button on Event Manager window to open the settings window of event.
Element: The element of the component controlled by value trigger.
Component: The component of device contains the previously element.
Device/System: The device/system contains the previously component.
Remove: Remove the element controlled by the event.
This action only removes the relation between the element and event and does not delete the
element.
5.3.7 Master Preset Change
This event is used for changing the Master Preset of Ateis devices. Each state can be linked to a
Master Preset. When a source triggers a Master Preset Change event, it will send a state number to
the event, then changes to the Master Preset linked to the state.

Ateis IDA8 Series Specifications

General

Brand	Ateis
Model	IDA8 Series
Category	Security System
Language	English