Ateis IDA8 Series User Manual

IDA8 Global-Net User Manual470
© 2020, ATEÏS. All rights reserved.
"Zone n Normal AMP Rating too low"
"Zone n BackUp AMP Rating too low" (where n = 1~8)
o A text message displays at the window [Machine Fault Record] in Ateis Studio, see the
picture as below.
A buzzing sound will be outputted to the monitoring speaker on the front panel of the IDA8C.
Troubleshooting: Check the amplifier power and wiring. Once it's recovered, the LOG will show:
"Zone n Normal AMP OK"
"Zone n Backup AMP OK"
7.1.22 BackupAmp Used State
A normal amplifier has failed and was replaced by the backup amplifier.
Indication:
LED Indicator: When this error is detected, the following LEDs will light up:
o G. Fault LED on the front panel of the IDA8C/S.
Log:
o The text messages display at the touch screen of the IDA8C:
"BackupAmp Used State"
"Machine X Zone Y Use Backup Amp Z" (Where X = machine ID, Y = 1~8 and Z =
1~n).
o A text message displays at the window [Machine Fault Record] in Ateis Studio, see the
picture as below.
A buzzing sound will be outputted to the monitoring speaker on the front panel of the IDA8C.
7.1.23 Local AteisNet Backup Mode
One of the local ATEIS net port has broken.
Indication:
LED Indicator: When this error is detected, the following LEDs will light up:
o G. Fault LED on the front panel of the IDA8C/S.
Log:
o "Local AteisNet Backup Mode" message displays play at the touch screen of the IDA8C.
o A text message displays at the window [Machine Fault Record] in Ateis Studio, see the
picture as below.

Ateis IDA8 Series Specifications

General

Brand	Ateis
Model	IDA8 Series
Category	Security System
Language	English