Log List 489
© 2020, ATEÏS. All rights reserved.
Ethernet Recovery Ethernet Broken
Low voltage detected when power supply is lower than
16VDC
Telephone card can't boot
Main Board FPGA Boot Failure
Main board FPGA chip can't boot
Global netcard doesn't exist
Global Ateis netcard isn't exist
Global ATEIS net card fails
Main Board FPGA Code Error
Main board FPGA chip fails
RU OK: Backup Device Online
RU Error: Backup Device Offline
Backup device status in the redundancy configuration
RU OK: Operation Mode Normal
RU Error: Operation Mode Fail
Operation mode status in the redundancy
configuration
Starts ATEIS Net deploying
Resets machine by ATEIS Studio
Recovery form low voltage status
All of the NTP server can't communicate
NTP Sync: yyyy/mm/dd hh:mm:ss
(ex: NTP Sync: 2013/7/12 08:15:42)
Global AteisNet Broken
Global AteisNet Recovery
Global ATEIS net card connection status
Voxnet Online
Voxnet Offline
Voxnet server connection status
ModBus Online
ModBus Offline
Modbus Connect:xxx
Modbus Disconnect:xxx
(xxx = client ip address)
Modbus client connection status
Global AteisNet Backup Mode
Global AteisNet Normal Mode
Global ATEIS Net backup connection status
Evac Event Beginning
Evac Event Ending
Any evacuation paging beginning/ ending
Store Configuration Table Start
Store Configuration Table End
Stores configuration table status
Store Configuration Success
Store Configuration Fail
Stores configuration table results
Update Success
Update Fail
Zone n Overflow
(n = 1~16)
5v Error
VS_D12V_RL Error
-12v Error
12v Error
48v Error
System 24v Error
Normal 24v Error
BackUp 24v Error
Store File Start
Store File End