EasyManua.ls Logo

AudioCodes Mediant 1000B - Web Parameters

AudioCodes Mediant 1000B
1281 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User's Manual 1000 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of the parameter, see ''Configuring Web and
Telnet Access List'' on page 82.
Local Users Table
Local Users
configure system >
user
[WebUsers]
The table defines management users.
The format of the ini file table parameter is as follows:
[ WebUsers ]
FORMAT WebUsers_Index = WebUsers_Username,
WebUsers_Password, WebUsers_Status,
WebUsers_PwAgeInterval, WebUsers_SessionLimit,
WebUsers_SessionTimeout, WebUsers_BlockTime,
WebUsers_UserLevel, WebUsers_PwNonce,
WebUsers_SSHPublicKey;
[ \WebUsers ]
For more information, see Configuring Management User Accounts
on page 74.
Additional Management Interfaces Table
Additional Management
Interfaces
configure system >
additional-mgmt-if
[AdditionalManagementInterf
aces]
The table defines additional management interfaces.
The format of the ini file table parameter is as follows:
[ AdditionalManagementInterfaces ]
FORMAT AdditionalManagementInterfaces_Index =
AdditionalManagementInterfaces_InterfaceName,
AdditionalManagementInterfaces_TLSContextName,
AdditionalManagementInterfaces_HTTPSOnly;
[ \AdditionalManagementInterfaces ]
For more information, see Configuring Additional Management
Interfaces on page 72.
65.1.2 Web Parameters
The Web parameters are described in the table below.
Table 65-2: Web Parameters
Parameter Description
Enable web access from all interfaces
web-access-from-all-interfaces
[EnableWebAccessFromAllInterfaces]
Enables Web access from any of the device's IP network
interfaces. The feature applies to HTTP and HTTPS
protocols.
[0] = (Default) Disable Web access is only through the
OAMP interface.
[1] = Enable - Web access is through any network
interface.
Note:
For the parameter to take effect, a device reset is
required.
Instead of using this parameter, you can use the
Additional Management Interfaces table to assign
specific IP network interfaces for management interfaces

Table of Contents

Other manuals for AudioCodes Mediant 1000B

Related product manuals