AudioCodes Mediant 1000B - IP Media Parameters

User's Manual 1252 Document #: LTRT-27055
Mediant 1000B Gateway & E-SBC
Parameter Description
sbc-emerg-sig-diffserv
[SBCEmergencySignalingDiffServ]
The valid value is 0 to 63. The default is 40.
65.12 IP Media Parameters
The IP media parameters are described in the table below.
Table 65-73: IP Media Parameters
Parameter Description
IPMedia Detectors
configure voip > media ipmedia >
ipm-detectors-enable
[EnableDSPIPMDetectors]
Enables the device's DSP detectors for detection features such
as AMD.
 [0] Disable (default)
 [1] Enable
Note:
 For the parameter to take effect, a device reset is required.
 The DSP Detectors feature is available only if the device is
installed with a License Key that includes this feature. For
installing a License Key, see ''License Key'' on page 815.
 When enabled (1), the number of available channels is
reduced.
Number of Media Channels
configure voip > sbc settings >
media-channels
[MediaChannels]
Defines the maximum number of DSP channels allocated for
various functionalities such as transcoding, IP streaming, IP
conferencing.
The maximum number of media channels depends on the
number of installed Media Processing modules (MPM). For
more information, see DSP Channel Resources on page 217.
The default is 0.
Note:
 For the parameter to take effect, a device reset is required.
 The SBC application does not require DSP channels. The
SBC application uses DSP channels only if media
transcoding is needed, where two DSP channels are used
per transcoding session.
 Other DSP channels can be used for PSTN interfaces.
[EnableIPMediaChannels]
Enables IP media channel support.
 [0] = Disable (default)
 [1] = Enable
Note:
 When the device is installed with an MPM, the parameter is
enabled by default.
 For the parameter to take effect, a device reset is required.
[IPmediaChannels] This table ini file parameter defines the number of DSP
channels that are "borrowed" from each of the device's digital
modules for IP media functionality. The format of the ini file
table parameter is as follows:
[ IPMediaChannels ]
FORMAT IPMediaChannels_Index =