Version 7.2 975 Mediant 1000B Gateway & E-SBC
User's Manual 60. Debugging Web Services
60 Debugging Web Services
If you have configured remote Web services (see Remote Web Services on page 272), you
can enable debugging of the remote HTTP clients. You can configure the debug level from
1 to 3, where 3 is the most detailed. The debug messages are sent to the Syslog server.
To configure debugging of Web services:
1. Open the Web Service Settings page (Setup menu > IP Network tab > Web Services
folder > Web Service Settings).
2. In the 'Debug Level' field (RestDebugMode), enter the debug level (or disable
debugging by configuring it to 0):
3. Click Apply.
To Next Page
Loading...
