Version 7.2 59 Mediant 1000B Gateway & E-SBC
User's Manual 6. Web-Based Management
a. From the drop-down list, select the Add new option; as shown in the example
below:
Figure 6-9: Selecting Add new Option
The table (e.g., IP Groups table) and dialog box in which the Add new option was
selected is minimized to the bottom-left corner of the Web interface and a dialog
box appears for adding a new row in the referenced-table (e.g., Proxy Sets table).
b. Configure the referenced-row and click Apply; the referenced-table (e.g., Proxy
Sets table) closes and you are returned to the dialog box in which you selected
the Add new option (e.g., IP Groups table), where the newly added row now
appears selected.
You may want to access the referenced-table (e.g., Proxy Sets table) to simply view all its
configured rows and their settings, without selecting one. To do this, click the View button.
To return to the dialog box of the table (e.g., IP Groups table) in which you are making your
configuration, click the arrow icon on the minimized dialog box to restore it to its
previous size.
6.1.6.3 Modifying Table Rows
The following procedure describes how to modify (edit) the configuration of an existing
table row. Remember that a gray-colored dot icon displayed next to a parameter's value
(as shown in the example below), indicates that it was changed from its default value:
To edit a table row:
1. Select the row that you want to edit.
2. Click the Edit button, located on the table's toolbar; a dialog appears
displaying the current configuration settings of the row.
3. Make your changes as desired, and then click Apply; the dialog box closes and your
new settings are applied.
4. If the Save button is surrounded by a red border, you must save your
settings to flash memory, otherwise they are discarded if the device resets (without a
save to flash) or powers off.
6.1.6.4 Deleting Table Rows
The following procedure describes how to delete a row from a table.
To Next Page
Loading...
