AudioCodes Mediant 1000B - Channel Parameters; Voice Parameters

Version 7.2 1097 Mediant 1000B Gateway & E-SBC
User's Manual 65. Configuration Parameters Reference
Parameter Description
and-profiles tel-profile
[TelProfile]
individual, "global" parameters). You can later assign these Tel Profile
IDs to other elements such as in the Trunk Group table (TrunkGroup
parameter). Therefore, Tel Profiles allow you to apply the same settings
of a group of parameters to multiple channels, or apply specific settings
to different channels.
The format of the ini file table parameter is as follows:
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupName,
TelProfile_IsFaxUsed, TelProfile_JitterBufMinDelay,
TelProfile_JitterBufOptFactor, TelProfile_IPDiffServ,
TelProfile_SigIPDiffServ, TelProfile_DtmfVolume, TelProfile_InputGain,
TelProfile_VoiceVolume, TelProfile_EnableReversePolarity,
TelProfile_EnableCurrentDisconnect, TelProfile_EnableDigitDelivery,
TelProfile_EnableEC, TelProfile_MWIAnalog, TelProfile_MWIDisplay,
TelProfile_FlashHookPeriod, TelProfile_EnableEarlyMedia,
TelProfile_ProgressIndicator2IP, TelProfile_TimeForReorderTone,
TelProfile_EnableDIDWink, TelProfile_IsTwoStageDial,
TelProfile_DisconnectOnBusyTone, TelProfile_EnableVoiceMailDelay,
TelProfile_DialPlanIndex, TelProfile_Enable911PSAP,
TelProfile_SwapTelToIpPhoneNumbers, TelProfile_EnableAGC,
TelProfile_ECNlpMode, TelProfile_DigitalCutThrough,
TelProfile_EnableFXODoubleAnswer, TelProfile_CallPriorityMode,
TelProfile_FXORingTimeout, TelProfile_JitterBufMaxDelay,
TelProfile_PlayBusyTone2Isdn;
[\TelProfile]
For a description of the parameter, see Configuring Tel Profiles on page
459.
65.9 Channel Parameters
This subsection describes the device's channel parameters.
65.9.1 Voice Parameters
The voice parameters are described in the table below.
Table 65-34: Voice Parameters
Parameter Description
Input Gain
configure voip > media voice >
input-gain
[InputGain]
Global parameter defining the pulse-code modulation (PCM) input
(received) gain control level (in decibels).
You can also configure the functionality per specific calls, using IP
Profiles (IpProfile_InputGain) or Tel Profiles
(TelProfile_InputGain). For a detailed description of the parameter
and for configuring the functionality, see ''Configuring IP Profiles''
on page 423 or Configuring Tel Profiles on page 459.
Note: If the functionality is configured for a specific profile, the
settings of the global parameter is ignored for calls associated with
the profile.